Wednesday , 26 April 2017

STM32F10xxx Cortex-M3

PDO – Personal Digital Oscilloscope

PDO Series oscilloscopes, the function of the digital oscilloscope using the advantages of the PC are designed with the aim to offer reasonable costs. It is capable of meeting the expectations of the designer with many features. PDO – Personal Digital Oscilloscope is available in two models; PDO-50 and PDO-100.                     Options: …

Read More »

Getting NewLib and printf to work with the STM32 and Code Sourcery Lite eabi

The Code Sourcery Lite tool chain is provided with the newlib C Library from Redhat. Because this is an embedded toolchain some stub functions known as System Functions must be provided by the embedded system that would normally be provided by a host operating system. The is shown by the fact that if you try to compile a C program that uses …

Read More »

Hardware debugging working with Eclipse and Code Sourcery Lite

This is a follow on from the Setting up Eclipse and Code Sourcery for STM32 Discovery Development. and so assumes you already have Eclipse working with the Code Sourcery Lite tool chain. What you will need Atollic True Studio Lite , which can be downloaded for free from the Atollic website here: Getting Started. Download and Install the Atollic True Studio …

Read More »

Setting up Eclipse and Code Sourcery lite for STM32 Discovery Development

Here is a step by step guide to setting up a Open Source Stm32 Arm based embedded development tool chain with the Eclipse IDE. It is Targeted for the ST32-Discovery demo board under Windows (This was implemented under Windows 7 64bit) and uses the open source Code Sourcery version of the Gnu Arm cross assembler. The project will be set up to …

Read More »

STM32 Discovery Development Board

The STM32 Discovery (STM32VLDISCOVERY) board is a low cost demo board featuring a STM32F100RBT6B system on a chip MCU from ST’s value line and comes with an intergrated STLink usb programmer. These boards are very low cost and can be had for about £8 in the UK. The STM32 Discovery board has most of the STM32F100RBT6B 64 pins exposed on DIL …

Read More »


This post describes the steps needed to make NGX’s USB ARM JTAG to work with OpenOCD in windows 7. This JTAG is compatible with colink JTAG and works with IAR Workbench and Keil uVision. To use with these IDEs there is a well defined methods/plug-ins available in the product page and in internet. However to use this JTAG with OpenOCD there is scarce resource in the internet. OpenOCD can be used …

Read More »